Dr. Hulda Clark "Zapper" DIY Kit

The kit comes with:

• 2x 1K resistors
• 2x 3.9K resistors
• 1x .0047 uf Capacitor
• 1x .01uf Capacitor
• Project Box with 9v compartment
• 1x Solderless Bread board - For prototyping 
• 1x General Purpose Circuit board
• 1x 9v snap connector
• 2x Banana jacks
• 2x Banana Plugs (Not shown in picture)
• 5ft Red Test lead wire (For Probe) (Not shown in picture)
• 5ft Black Test lead wire (For Probe) (Not shown in picture)
• 1x micro toggle switch
• 1x Red LED in panel holder
• Wiring schematic

You will need to fabricate your own "Probes". Typically using copper pipe, wire,

According to Dr. Hulda Clark, the recommended use is:

• • 7 minutes of use
• • 20-minute break
• • Repeat 3 times

This cycle is believed to “zap” and eliminate a significant portion of pathogens in the body.

Specification:

• Frequency: ............................... 30kHz-33kHz
• Wave form: …………… Positive offset square
• Duty cycle: ……………….…...…….……. 50%
• Amplitude output: …………….....…… 6V - 8V
• Current output: ………….……..... 6mA- 10mA
• Battery: ...................................................... 9V
• Consumption: ............................ 15mA-30mA
  

Terms of Use Notice

By purchasing or using this product, you acknowledge and agree that:

It is not a certified medical device. It is offered for personal experimentation and wellness purposes only. No health claims are made or implied. You are responsible for using the product responsibly and legally in your jurisdiction.